Parallel port

From Wikipedia, the free encyclopedia

It has been suggested that LPT, Centronics and IEEE 1284 be merged into this article or section. (Discuss)

This article is about the Centronics style port. For the concept in general, see Parallel communications.

A DB-25 parallel printer port on the back of a laptop.

A parallel port is a type of socket found on personal computers for interfacing with various peripherals. It is also known as a printer port or Centronics port. The IEEE 1284 standard defines the bi-directional version of the port.

For the most part, the USB interface has replaced the Centronics-style parallel port — as of 2006, most modern printers are connected through a USB connection, and often don't even have a parallel port connection. On many modern computers, the parallel port is omitted for cost savings, and is considered to be a legacy port. In laptops, access to a parallel port is still commonly available through docking stations.

1 Uses
2 Port addresses
3 Interfacing to
4 See also
5 References

[edit] Uses

Printers
Zip drive
some old scanners
some early sound cards
some old Webcams
peripheral devices such as EPROM programmers, joysticks for emulators

[edit] Port addresses

Traditionally IBM PC systems have allocated their first three parallel ports according to the configuration in the table below.

PORT NAME	Interrupt #	Starting I/O	Ending I/O
`LPT1`	`IRQ 7`	`0x3bc`	`0x3bf`
`LPT2`	`IRQ 5`	`0x378`	`0x37f`
`LPT3`	`IRQ 5`	`0x278`	`0x27f`

If there is an unused LPTx slot, the port addresses of the others are moved up. (For example, if a port at 0x3bc does not exist, the port at 0x378 will then become LPT1.) The IRQ lines, however, remain fixed (therefore, 0x378 at LPT1 would use IRQ 7). The port addresses assigned to each LPTx slot can be determined by reading the BIOS Data Area (BDA) at 0000:0408.

Bit to Pin Mapping for the Standard Parallel Port (SPP):

Address		MSB							LSB
	Bit:	7	6	5	4	3	2	1	0
`Base`	Pin:	9	8	7	6	5	4	3	2
`Base+1`	Pin:	~11	10	12	13	15
`Base+2`	Pin:					~17	16	~14	~1

~ indicates a hardware inversion of the bit.

[edit] Interfacing to

In Windows 98 and previous operating systems, programs could access the parallel port with simple outportb() and inportb() subroutine commands. In Windows NT, 2000 and XP, the microprocessor is operated in a different security ring, and accesses to the parallel port are inhibited, unless using the required driver. This improves security and arbitration of device contention. However this also means that many legacy products will not work with later operating systems such as Windows XP.