Flicker noise
From Wikipedia, the free encyclopedia
Flicker noise is a type of electronic noise with a 1/f, or pink spectrum. It is therefore often referred to as 1/f noise or pink noise, though these terms have wider definitions. It occurs in almost all electronic devices, and results from a variety of effects, such as impurities in a conductive channel, generation and recombination noise in a transistor due to base current, and so on. It is always related to a direct current.
In electronic devices, it is a low-frequency phenomenon, as the higher frequencies are overshadowed by white noise from other sources. In oscillators, however, the low-frequency noise is mixed up to frequencies close to the carrier which results in oscillator phase noise.
Flicker noise is often characterized by the corner frequency fc between the regions dominated by each type. MOSFETs have a higher fc than JFETs or bipolar transistors which is usually below 2 kHz for the latter.
Flicker noise is found in carbon composition resistors, where it is referred to as excess noise, since it increases the overall noise level above the thermal noise level, which is present in all resistors. In contrast, wire-wound resistors have the least amount of flicker noise. Since flicker noise is related to the level of DC, if the current is kept low, thermal noise will be the predominant effect in the resistor, and the type of resistor used will not affect noise levels.
[edit] See also
[edit] References
- Johnson, J. B. (1925). "The Schottky effect in low frequency circuits". Physical Review 26: 71–85. DOI:10.1103/PhysRev.26.71.
- Schottky, W. (1918). "Über spontane Stromschwankungen in verschiedenen Elektrizitätsleitern". Annalen der Physik 362: 541–567.
- Schottky, W. (1922). "Zur Berechnung und Beurteilung des Schroteffektes". Annalen der Physik 373: 157–176.
- Rane Pro Audio Reference definition of "flicker noise"
- Noise Tutorial
- Noise Analysis In Operational Amplifier Circuits — Texas Instruments application report
