Gas-operated reloading

From Wikipedia, the free encyclopedia

Gas-operated firearm. 1) gas port, 2) piston head, 3) rod, 4) bolt, 5) bolt carrier, 6) spring

Gas-operation is a system of operation used to provide energy to autoloading firearms. In gas-operation, a portion of high pressure gas from the cartridge being fired is used to extract the spent case and chamber a new cartridge. Energy from the gas is harnessed through either a port in the barrel or trap at the muzzle. This high-pressure gas impinges on a surface such as a piston head to provide motion for unlocking of the action, extraction of the spent case, ejection, cocking of the hammer or striker, chambering of a fresh cartridge, and locking of the action.

Other autoloading systems are^[1]:

Recoil operation uses the rearward movement of parts of the weapon in response to the bullet moving forward, as described by Newton's third law of motion.
Gatling and other mechanical means utilize mechanical energy from an operator turning a crank.
Chain and others utilize external power through electrical or hydraulic energy for operation.
Blowback firearms use the expanding gas impinging on the cartridge itself to push the bolt of the firearm rearward.

1 Gas systems
2 Misconceptions
3 References
4 External links

[edit] Gas systems

There are four principal types of gas operation: short-stroke, long-stroke, gas trap, and direct impingement.

A short-stroke gas system is defined as one which uses high pressure gas from the middle portion of the barrel that impinges on the piston head for a short period of time before excess gas is either cut-off (M14) or vented (AK-47) or the piston head reaches a stop (M1 Carbine). The distance the piston travels under pressure is generally less than its diameter.^[2] The piston may or may not be attached to the bolt carrier. This is the most common type of gas operation.

A long-stroke gas system is generally defined as one which the stroke of the piston under pressure is greater than its diameter.^[3] Because of the greater dwell time, gas must be ported from the barrel very near the muzzle of the weapon as in the M1 Garand. This relatively lower pressure gas acts over a longer period of time to impart the same amount of energy to the operating system. Because the operating parts are longer, they are necessarily heavier and this system is not used in modern weapons.

A gas trap system is similar to long-stroke operation, however gas is 'trapped' after leaving the muzzle. The "Bang" rifle and early "gas trap Garand" rifles use this system. The German MG-42 machinegun and other recoil operated weapons use this energy in combination with recoil energy for more reliable and energetic operation of the weapon. The gas trap system is also obsolete.

The direct impingement method of operation vents gas through a tube to the working parts of a rifle where they directly impinge on either the bolt itself as in the M16 rifle, or the bolt carrier proper.

[edit] Misconceptions

The terms short-stroke and long-stroke are often confused by both laymen and experts. The stroke is that portion of time when combustion gases contact the piston head prior to venting. It is not the total length the piston head might travel during the cycling of the action. The commonly reported misconception is that a piston being rigidly affixed to the bolt carrier is what constitutes a long-stroke system. The AK-47 is commonly referred to as a long-stroke action while the Armalite AR-18 is often used as an example of a short-stroke system. In fact, the stroke is virtually the same and the gas port is in nearly the same location along the barrel for both rifles. ^[4]