William H. Natcher Bridge
From Wikipedia, the free encyclopedia
| ' | |
| Official name | William H. Natcher Bridge |
|---|---|
| Carries | U.S. Highway 231 |
| Crosses | Ohio River |
| Locale | Owensboro, Kentucky to Rockport, Indiana |
| Total length | 4,505 feet (1,373 m) |
| Width | 67 feet (20 m) |
| Opening date | October 21, 2002 |
|
|
The William H. Natcher Bridge is a cable-stayed bridge that carries U.S. Highway 231 over the Ohio River. The bridge connects Owensboro, Kentucky to Rockport, Indiana and opened on October 21, 2002. It is named in honor of William Huston Natcher, a former United States Representative who served Kentucky's 2nd Congressional District from 1954 until his death in 1994. The bridge project was named for Natcher only three months before his death. It is owned by the Commonwealth of Kentucky and was commissioned by the Kentucky Transportation Cabinet, in cooperation with the Indiana Department of Transportation and the Federal Highway Administration.
Contents |
[edit] Specifications
The William H. Natcher Bridge is 4,505 feet (1,373 m) in length (including its approaches) and 67 feet (20 m) wide. It is supported by cables connected to two identical diamond-shaped A-frame towers, each 374 feet (114 m) tall. At the time of its construction, it was the United States' longest cable-supported bridge over an inland waterway.
[edit] Construction
The concept for a new bridge to serve Owensboro dates back to 1987, when a Green River Area Development District study recommended a new bridge to connect to U.S. Highway 231 in Rockport, where the highway came to an intersection mere feet away from the river's bank. Congressman Natcher first began seeking federal funds for the new bridge in 1988. Construction ran across the late 1990s and early 2000s at a cost of US$70 million (approximately $40 million from federal sources, $30 million from state sources). Originally slated for a 1996 completion, the bridge was the victim of numerous funding delays from both the federal and state levels. Though the concrete piers (the bases which support the upright towers) were installed in 1995, construction on the bridge itself did not begin until 1998. Even then, the original plan was to have the bridge completed by the end of 2000, but the builders said that goal was unrealistic due to the complicated nature of the cable installation. It was finally dedicated on August 16, 2002, but did not open to traffic until October 21, 2002 due to more construction delays. The Natcher Bridge was designed by Parsons, Brinckerhoff, Quade & Douglas, Inc. and built by Traylor Brothers of Evansville.
[edit] Reasons for building
The bridge was constructed for two reasons: to relieve traffic congestion on the aging Glover Cary Bridge in downtown Owensboro (approximately 6 miles downstream from the Natcher Bridge), and as part of a larger project to make U.S. Highway 231 a four-lane road between Owensboro and Interstate 64 near Dale, Indiana (this project is underway, but will not be completed until at least 2012).
[edit] Effects of bridge
A new four-lane expressway, from U.S. Highway 60 near Owensboro to the Natcher Bridge was constructed. Upon the completion of the bridge, U.S. Highway 231 was rerouted onto the new four-lane highway and around Owensboro, Kentucky. U.S. Highway 231 in the city of Owensboro was renumbered to Kentucky Route 2155 and in Indiana from the old Glover Cary Bridge to the Indiana four-lane expressway approach, old U.S. Highway 231 was renumbered to State Road 161.
[edit] See also
[edit] External links/References
- William H. Natcher Bridge at KentuckyRoads.com
- William H. Natcher Bridge at Parsons Brinckerhoff, bridge designer
- William H. Natcher Bridge at Bridges & Tunnels.
- Structurae bridge profile
| Bridges of the Ohio River | |||
|---|---|---|---|
| Upstream Bob Cummings - Lincoln Trail Bridge KY 69 / IN 237 |
William H. Natcher Bridge |
Downstream Glover Cary Bridge KY 2155 / IN 161 |
|
