Working terrier

From Wikipedia, the free encyclopedia

A working terrier is a terrier that goes to ground in a natural earth against formidable quarry (as opposed to the artificial earths used at American earthdog trials). Terriers that rat or bush rabbits or work wild game in brush piles or barns are not working terriers, but "sporting terriers" — a term that encompasses a wide variety of work not done underground.

In terrier work, the terrier is intended to locate its quarry, and either bark and bolt it free or to a net, or to trap or hold it so that it can be dug down to and killed or captured. Animal welfare organisations such as the League Against Cruel Sports criticise the activity, arguing that serious injury can be caused to both animals when the quarry is trapped or fights the terrier.^[1] Hunting below ground with terriers is largely illegal in Britain under the Hunting Act 2004.

A working Jack Russell Terrier exits a den pipe.

1 Requirements of a working terrier
2 Terrier work as vermin control
3 Early history
4 Rootstock
5 Tools and technique
6 Controversy in the UK
7 See also
8 Notes
9 References
10 External links

[edit] Requirements of a working terrier

The most important qualification of a working terrier is an owner who works it. A terrier is not a working terrier by virtue of its breeding alone. The second most important quality of a working terrier is small chest size. Though the chest size of the working terrier that can be used in any given situation may rise or fall depending on the size of the den pipe, smaller dogs generally do as well or better than larger dogs. The reason for this is rather simple: a small dog can get to the quarry without having to dig, and arrives at the quarry without fatigue.

If a dog is too large, he will not be able to get past turns in the tunnel, and will have to be dug to every few feet. If a dog has to dig to the quarry when the tunnel tightens down (as it invariably will), the dog will have to push dirt behind it to progress, which can result in the dog being “bottled” by dirt from behind. In such a situation the dog will have a very difficult time getting out on its own if it cannot turn around.

With two animals underground (dog and quarry), it is essential that a flow of air be maintained to avoid asphyxiation. The tighter a dog is in the pipe, the more that air flow will be constricted. In addition, a small dog is able to maneuver better in order to avoid being bitten. As a consequence, small dogs often receive less damage underground than larger dogs, which are more likely to find themselves jammed in a den pipe, face to face with the quarry, and unable to move forward or backward. No good can come from such a situation.

Working terriers and tools for terrier work.

Other important requirements of a working terrier are an essential gameness, a good nose, and an ability to problem solve in order to avoid coming to harm underground.

[edit] Terrier work as vermin control

A wide variety of game is worked below ground with terriers, including red fox, groundhogs (also known as woodchucks), raccoons, opossums, nutria (also known as coypu), European badger, American badger, and tanuki (also known as raccoon dog).

Terrier work is not a very efficient way of hunting vermin, though over 500 members of the Royal College of Veterinary Surgeons[1] agree that it is a humane way to reduce fox numbers, and is quite selective. Because of these characteristics, terrier work is considered an ideal way to control certain nuisance wildlife in farm country. According to a 1994 survey by the British Association for Shooting and Conservation, 9% of foxes killed by UK gamekeepers were killed following the use of terriers.[2]

The inefficiency of terrier work means that, unlike poisons and traps, there is no danger that a species can be wiped out over a large area, and little chance that an adult will be terminated with unseen young still in the den. In addition, collateral damage, in the form of killing non-target species, is zero.

Though inefficient, a team of terriers, when coupled with an enthusiastic digger, can control red fox, raccoon or groundhog on small farms where their presence might be a problem for chickens, geese, wild bird populations, and crop production. Because terrier work is selective, animals can be dispatched, or else they can be moved and relocated to nearby farms, forests or waste areas where they will do no harm.

In the U.S., an increase in red fox, gray fox, groundhog, raccoon, possum and nutria can be traced to increased forest fragmentation in the Eastern U.S. (fragmented forests bordering farm land are ideal for dense populations of meso-pretators), the importation of two non-native species (red fox and nutria), and the spread of opossum, raccoon, and red fox populations into western and northern states as food sources have increased.

[edit] Early history

Terrier work, as it is known today, began with the rise of the Enclosure Movement in the late 18th Century in England. With enclosure, people were moved off the land and into cities and towns, and sheep and other livestock were moved into newly walled, hedged and fenced fields. Vast expanses of enclosed open spaces proved perfect for mounted fox hunting – a sport that had arrived in the UK from France in the late 17th Century.

The first mounted fox hunts were described by Sir Walter Scott, who also described the first working terriers in the UK. The first true breed of working terrier that bears a resemblance to what we see in the field today is the Jack Russell Terrier. The Jack Russell Terrier is named afer the Reverend John Russell, whose long life (1795-1883) encompasses the entire early history of mounted fox hunts in the UK and who is credited with breeding the first fox-working white-bodied terrier used in the field today.

With the rise of the Enclosure Movement in the late 18th Century and early 19th Century came the control of sires and the rapid improvement in livestock herds. As breeds were improved, livestock shows were held to display these improvements. From these livestock shows grew the first dog shows.

The first dog show appeared in the UK in 1859, the same year that Charles Darwin’s the "Origin of Species" was first published. Both Darwin’s book and the first dog shows drew much of their inspiration from the rapid “speciation” of new livestock breeds that had first begun with Robert Bakewell’s efforts to control sire selection. If livestock breeds could be rapidly “improved” through controlled breeding, clearly the same thing could be done with dogs.

Between 1800 and 1865, the number of dog breeds in the UK climbed from 15 to over 50, and it exploded even further with the creation of the Kennel Club in 1873.

With the rise of Kennel Club dogs shows, every manner of rough working dog was soon being put up as an "ancient breed." In fact, most of these breeds were very new or even one-off dogs, and most histories were invented or dramatically elaborated on by get-rich-quick breed promoters.

[edit] Rootstock

In the world of working terriers, there are but two roots – colored dogs from the north (Scotland and Wales), and white dogs from the south (England). From these two roots spring a variety of Kennel Club dogs and every type of working terrier commonly found in the field today.

The "Fell Terrier" is the original non-pedigree colored working dog of the north. From this diverse gene pool has sprung the Kennel Club Welsh Terrier, the Lakeland Terrier and the Border Terrier. Today, only the Border Terrier is occasionally found in the field. This is not to say the working Fell Terrier has disappeared -- it still exists by that name among working terrier enthusiasts.

Today's working Fell Terrier may be brown, black, red, or black-and-tan, and may be smooth, wire or broken coated. The dog may be called a Fell terrier or a "working Lakeland" or a "Patterdale Terrier." A German variety of the Fell Terrier is called the "Jagdterrier," but the standard for this dog is on the large size, and as a consequence it is most useful in large pipes, artificial earths, or when it has been bred down to a 12-13 inch size.

From the southern part of England have come the white fox-working dogs whose origins are the same as those of the Jack Russell Terrier. Kennel Club breeds derived from these mainly-white coated dogs include the Smooth Fox Terrier, the Wire Fox Terrier, the Sealyham Terrier and (most recently), the Parson Russell Terrier and Russell Terrier. None of these Kennel Club breeds are commonly found working in the field today.

The absence of white-bodied working dogs in the Kennel Club does not mean that white fox-working dogs have disappeared. The working Jack Russell Terrier is still very much alive and is as common as ever, presenting itself in an astounding variety of coats [smooth, broken and wire coated or rough), sizes (10 inches to 15 inches tall with most working dogs sized 10 to 13 inches tall), and coat colors (from pure white to 49 percent colored with tan and black markings). There is even a new type of working Jack Russell – the “Plummer Terrier” first created by Brian Plummer in the 1970s and breeding true since the mid 1980s.

What of all of the other Kennel Club breeds of terriers? Most of these terrier were never true working terriers. Some were small farm dogs used to catch rats and keep foxes from invading the farm yard. Some saw work as turnspit dogs or were used by farmers to bust rabbits from hedges and thickets. Most, however, were created as pets and remain as pets to this day.

The rather pedestrian history of most of the terriers breeds created between 1850 and 1910, is that these dogs were created for the show ring by for-profit breeders and show ring enthusiasts. Most of these terrier breeds never saw underground terrier work of any kind. Occasionally an early breeder of one terrier type or another is reported to have worked his or her dog, but the story is generally vague and almost always episodic. Let it be said simply: the fact that a handful of prototype dogs of a given breed allegedly did a small bit of work more than 100 years ago does not qualify the breed to be considered a "working dog." Terrier work is not something that disappeared with schooners, candles and buggy whips; it is a continuing pastime, and the dogs working in the field today are the same type of working terrier that have always existed.

[edit] Tools and technique

The tools used for terrier work have essentially remained unchanged for more than 400 years – a small-chested and very game working terrier, a good roundpoint shovel, a digging bar, a brushhook to clear away hedge and bramble, fox nets, water for the dog and digger, and a snare to remove the quarry or a gun or blunt instrument to dispatch it.

The only “modern” piece of equipment found in a terrierman’s kit that might look foreign to a terrierman from the late 18th Century is an electronic radio collar used to help locate the dog underground and speed the dig. Locator collars have greatly increased the safety of dogs when underground, and no sensible digger will put a dog to ground without one today.

[edit] Controversy in the UK

Terrier work has come under criticism from animal welfare groups in the UK, particularly in connection with fox hunting, where terriers may be used to flush out a fox who has gone underground. Organisations such as the League Against Cruel Sports have produced a range of reports on the working terrier. [3] Alan Williams MP proposed a private members bill, the Protection of Dogs Bill seeking to ban the activity in 1994, [4] but it was not banned in the UK until the passage of the Hunting Act 2004. The Act outlaws terrier work unless it complies with a number of strict conditions designed for gamekeepers. [5] The owner of the dog must have permission to be on the land to reduce fox numbers in order to protect game birds, must have a locator collar on the dog, and may only use one dog at a time below ground. [6] Terrier work is supported by a pro-hunting veterinary group as the most humane way to reduce fox numbers where predator abatement is needed. [7]

[edit] See also

[edit] Notes

^ "What is terrier work?" League Against Cruel Sports, retrieved January 16, 2007.

[edit] References

Burns, Patrick. American Working Terriers, 2005. ISBN 1-4116-6082-X [8]
Chapman, Eddie. "The Working Jack Russell Terrier," 1994. No ISBN [9]
Fischer, John, "Vulpicide in South Nottinghamshire in 1865"[10]
MacDonald, David. "Running With the Fox." 1987. ISBN 978-0044400844 [11]
League Against Cruel Sports campaign against terrier work
"Badger baiter banned after terriers hurt", Sheffield Today, August 8, 2005

[edit] External links

Bait

Retrieved from "http://en.wikipedia.org../../../w/o/r/Working_terrier.html"

Categories: Dog types | Dog breeds | Terriers | Hunting | Animal welfare